The EZ Door Steel for FMI Fireplaces

The EZ Door Steel Fireplace Doors

• Quality Constructed 3/4" Low Profile Steel Frame for durability
• Fine Textured Black Finish (Powder Coat Finish)
• Available Only As An Inside Fit
• Tempered Bronze, Gray, or Clear Glass
• Bifold doors or Full Swing Bifold Trackless Doors
• Lifetime Warranty on Glass - 5 Year Warranty on the Frame
• Please Note:If your fireplace opening exceeds 44" x 28", check out our EZ Door Plus which has larger sizes available

How to Measure for Prefab (Factory Built) Fireplace Doors.

If you have a model number listed on our website you will only need to verify your opening height and width.

When building your door from the ground up we need an extra set of measurements for recess depth) and your pictures sent to sales@brick-anew.com. This allows us to be sure that our door system will work properly and we know that you have measured in the right places.

1. Height.

2. Width

3. Top recess depth

4. Bottom recess depth

5. Side recess depth

How to Install the EZ Door Steel

 For the majority of the fireplaces, we use a Frame with the 2 (Bi-Fold) Glass Doors to properly retrofit your fireplace.

This frame is installed by sliding the frame back into the opening approximately 3/4 inch. The frame is secured by 4 screws. Next the doors are snapped into the newly installed frame. This ensures a proper fit every time.

 The EZ Steel Fireplace Doors are mounted inside the opening. See diagram below.

The recess depth is an important measurement because you want your fireplace doors and new frame pieces to lay flush to the fireplace. The new fireplace doors will need to push back in a little ways on all four sides and some of our doors require more recess depth than others. 

Here is more information on measuring and installing your new fireplace doors.

How to Measure for Fireplace Doors

How to Install Fireplace Doors